Geophysics
Afshin Amiri; Majid Bagheri; Mohammad Ali Riahi
Abstract
Seismic well tying is a crucial part of the interpretation phase in exploration seismology. Tying wells usually involves forward modeling a synthetic seismogram from sonic and density logs and then matching the obtained synthetic seismogram to the seismic reflection data. A huge amount of time is required ...
Read More
Seismic well tying is a crucial part of the interpretation phase in exploration seismology. Tying wells usually involves forward modeling a synthetic seismogram from sonic and density logs and then matching the obtained synthetic seismogram to the seismic reflection data. A huge amount of time is required to deal with it, yet the outcome signal may not be satisfying and may be suffering a low cross correlation between the seismic signal and the synthetic one; it also requires a high quality synthetic trace. Another problem with the so-called manual tying is that the tying process is not repeatable, indicating that one can rarely obtain the same stretched and squeezed signal if the tying procedure is repeated. In recent years, some researchers have used the dynamic time warping (DTW) method to address well tying problems. They have obtained good results according to the correlation between the seismic signal and the warped synthetic signal. This research demonstrates that the result will be better if filtering is applied before tying, and then the warped signal is smoothed. We also propose a simpler algorithm for extracting a warped signal from the warping curve and the original synthetic trace, which gives rise to better performance for well tying.
Petroleum Engineering – Reservoir
Abiodun Ogbesejana; Oluwadayo Sonibare; Zhong Ningning; Oluwasesan Bello
Abstract
Crude oils and source rocks from the northern and offshore Niger Delta basin, Nigeria, have been characterized by gas chromatography-mass spectrometry in terms of their origin and thermal maturity based on the distribution of chrysene and its derivatives. The crude oils and source rocks were characterized ...
Read More
Crude oils and source rocks from the northern and offshore Niger Delta basin, Nigeria, have been characterized by gas chromatography-mass spectrometry in terms of their origin and thermal maturity based on the distribution of chrysene and its derivatives. The crude oils and source rocks were characterized by the dominance of chrysene over benzo[a]anthracene. 3-methylchrysene predominated over other methylchrysene isomers in the oils, while 3-methylchrysenes and 1-methylchrysenes were in higher abundance in the rock samples. The abundance and distribution of chrysene and its derivatives allow source grouping of the oils into three families. However, this grouping disagrees with the results obtained from well-established aromatic source grouping parameters. The maturity-dependent parameters computed from chrysene distributions (MCHR and 2- methylchrysene/1-methylchrysene ratios) indicated that the oils have a similar maturity status, while the rock samples are within an immature to early oil window maturity status, which was further supported by other maturity parameters computed from the saturate and aromatic biomarkers and vitrinite reflectance data. The abundance and distribution of chrysene and its derivatives were found to be effective in determining the thermal maturity of crude oil and source rock extracts in the Niger Delta basin, but they may not be a potential source-dependent biomarker in the crude oils and rock extracts from the basin.
